- ページ 30
冷蔵庫 Miele K 852iのPDF 操作および設置マニュアルをオンラインで閲覧またはダウンロードできます。Miele K 852i 40 ページ。
Miele K 852i にも： 操作および設置マニュアル (44 ページ)
ページを印刷する
Installation
This appliance must be built in,
otherwise it could tip up.
The appliance should be installed in a
dry well ventilated room.
The room temperature should not go
above or below the climate range for
which the appliance is designed. The
higher the ambient temperature of the
room the more energy the appliance re-
quires to operate. It should not be in-
stalled where it is exposed to direct
sunlight or directly adjacent to a heat-
producing appliance such as an oven
or a radiator.
The appliance is desigend for a particu-
lar climate range (ambient room tem-
perature), and should not be used out-
side this range. The climate range of
this appliance is stated on the data
plate inside the appliance.
SN
N
ST
T
Operating in a room which is too cold
will cause the cooling system to switch
off for too long causing the internal tem-
perature in the appliance to rise with
the risk of food deteriorating and going
off.
30
+10 °C to +32 °C
+16 °C to +32 °C
+18 °C to +38 °C
+18 °C to +43 °C
Air at the rear of the appliance gets
warm. The appliance housing unit must
be constructed to allow sufficient
space for ventilation. Miele kitchen
units are designed to provide this venti-
lation.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance for air to circulate.
The air inlet to the appliance is via the
plinth in the housing unit.
The cross section of the air inlet and
outlet must be at least 200 cm
sure that air can circulate without hinde-
rance. Otherwise the appliance has to
work too hard resulting in an increase
in electricity consumption and damage
to the compressor.
The air inlet and outlet must not be
covered or blocked in any way.
They should be dusted on a regular
basis.
Before installation remove the seal-
ing strip etc. from the outside of the
appliance and take any accessories
out of the inside of the appliance.
Remove any cable clips from the
rear of the appliance.
Check that all parts at the rear of the
appliance are unhindered.
2
to en-