- ページ 17

クックトップ Miele CS 1112のPDF 操作および設置マニュアルをオンラインで閲覧またはダウンロードできます。Miele CS 1112 40 ページ。 Ceramic combiset
Miele CS 1112 にも: 操作およびインストール手順 (40 ページ), 操作およびインストール手順 (40 ページ), 操作およびインストール手順 (40 ページ), 操作およびインストール手順 (48 ページ), ユーザーマニュアル (45 ページ), 操作およびインストール手順 (40 ページ)

Miele CS 1112 操作および設置マニュアル
Do not use a steam cleaner to clean
this appliance. Steam could
penetrate electrical components and
cause a short circuit. Pressurized
steam could cause permanent
damage to the surface and to
components for which the
manufacturer cannot accept
responsibility.
Do not use any sharp pointed
objects which could damage the
seal between the ceramic surface,
the surrounding frame and the
countertop.
Never use abrasive cleaners,
caustic (oven) cleaners, dishwasher
detergent, scouring pads, steel wool
or hard brushes. They will damage
the surface.
The ceramic surface can be cleaned
using a cleaner for ceramic
surfaces. Follow the manufacturer's
instructions.
Make sure that no cleaner residue
remains on the ceramic surface by
carefully wiping the combiset with a
damp cloth. They may damage the
combiset or produce toxic fumes
when heated.
Be sure that pot and pan bases are
clean and dry.
After cleaning dry the ceramic
surface with a soft cloth to prevent a
build up of limescale deposits.

Cleaning and care

Clean any spills immediately before
they become difficult to remove.
Clean the appliance regularly,
preferably after each use. Allow the
appliance to cool before cleaning.
Ceramic surfaces
^ Wipe off any soiling using a damp
cloth. Stubborn soiling is best
removed with a shielded scraper
blade.
^ Apply a ceramic cleaner (available
from Miele) using a soft cloth or
paper towel.
^ To remove any limescale deposits or
metallic residue apply a ceramic
cleaner using a soft cloth or use a
shielded scraper blade if necessary.
^ After cleaning wipe the ceramic
surface with a damp cloth and dry.
A cleaner with a special additive to
prevent water marks and smears on the
ceramic surface may be used.
Any melted solids like sugar, plastic or
aluminum foil should be removed as
quickly as possible, while the burner is
still warm. If they are allowed to harden
the combiset may become pitted.
^ Turn the burner off.
^ Using a shielded scraper blade,
scrape the melted item immediately
off the burner while it is still hot.
Use caution: Danger of burns!
^ Allow the combiset to cool and clean
as previously described.
17