ページを印刷するRK10
RK10
RK10S S S S
RK10
Roofing saw
1.14. Using the machine
When using the machine the operator must comply with the following instructions:
1. Check the machine before use.
2. Before commencing work check if it is safe to start the machine with out endangering
the operator or other persons.
3. Use prescribed personal safety aids while working. (Helmet, earmuffs, safety shoes,
goggles, respirator, gloves...).
4. Do not start the machine in enclosed area.
5. While working monitor the machine for unusual sounds or smoke which may indicate
defect. When defect is indicated immediately stop the machine and call for expert
repair.
6. Always switch off the engine when refuelling. Take care that the fuel does not come
into contact with hot parts of the engine. Wipe out immediately any spillage.
7. !ATTENTION! It is important to immediately repair or change improperly sealed or
leaky fuel tank and lines. Improperly sealed or leaky fuel tank and lines may cause an
explosion.
8. It is necessary to provide an adequate supply of fresh air for the operator, when using
the machine in enclosed areas (tunnels etc.).
9. When finish working, switch off the engine and move the machine the secure place
and insure against unauthorized use.
1.1.5. Checkups, maintenance, service and repair
•
regularly check the technical state of the machine.
•
if fault or damage is discovered ensure expert repair.
•
repair or service may bee carried out only by qualified personnel from a
manufacturer's service organisation.
•
it is prohibited to carry repairs or service at places where the safety of work is not
ensured and can be affected by outside impingement, such as falling objects, collision
with other machinery etc.
•
changes and alteration to the machine can be carried out only with the explicit
agreement of the manufacturer!
1.2. Transporting the machine
1. Always transport the machine in a secured position
on its transport wheels.
2. When transporting secure the machine against
overturning, moving or falling off.
3. Never transport the machine with the engine running!
Page 3 of 8