- ページ 3

扇風機 DIAL CASS-PNL-18-24-36のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DIAL CASS-PNL-18-24-36 4 ページ。 For cassette panel

ページを印刷する

2.3.2 For cassette

cooling capacity＞18000Btu

（

Step 1

Remove the corner pocket cover as shown below(4 portions).

Pull the fixing hook towards the arrow mark according to the order "①",

"②" and "③".

The corner pocket cover can be lifted.

After lifting, move it in "④"direction, disconnect the L-shaped hook and

dismantle the corner pocket cover.

Confirm the L-shaped hook comes off securely before removing the

corner pocket cover.

①

③

Fixing Hook

Fig.2.4 Removing Corner Pocket Cover

Step 2

Pull down the U-shaped hook (at 2 positions) located at the indoor unit

side.

Step 3

Set the corner of the refrigerant connection portion of the indoor unit to

the position indicated as "Ref. Piping",and catch the C-shaped hinge (2

positions) onto the U-shaped hooks (2 positions) .

Step 4

Mount the air panel onto the air panel fixing position by using the

factory-supplied fixing screws (M6 long screws).

Electrical

Control Box

Refrigerant Pipe

Connections

Stamp

"Ref. Pipe"

C-Shaped Hinge

(Q'ty 2)

Fig.2.5 Installation

Step 5

Check to ensure that there is no gap around the contacting surface

between the indoor unit and the air panel. Any gap may cause air

leakage or dewing(see fig.2.3).

Step 6

Attach the corner pocket covers after mounting air panel.

(Panels with display board should connect line with panel and

electric box first .)

1) Catch the band at the rear side of the cover for the corner

pockets onto the projection of the panel as shown below.

supporting panels

）

Fixing Hook

Corner Pocket Cover

②

Fixing Hook

④

L-Shaped Hook

Indoor Unit

U-Shaped

Hook

Fixing Plate

(Indoor Unit)

Air Panel

Long Screw

(Q'ty 4)

Band

2)Catch the L-shaped hook located at the rear side of the cover

for the corner pockets onto the square hole of the air panel.

L-Shaped Hook

Fixing Hook

(3 Portions)

To remove the corner pocket cover;

1) "1" the corner position of the corner pocket cover can be

lifted by inserting coin or slotted screwdriver and twisting.

With keeping this state, repeat the same procedure at the

position "2" and "3". The whole corner pocket cover can be

lifted .

After disconnecting the fixing hook (3 positions), disconnect

the L-shaped hook and remove the corner pocket cover.

Confirm the L-shaped hook comes off securely before

removing the corner pocket cover.

2) Slide the corner pocket cover in the allowed direction.

Projection

NOTE

Coin or Slotted Screwdriver

Lifting

Corner Position