- ページ 2

セキュリティシステム Allo RemoteControl HSCU1CのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Allo RemoteControl HSCU1C 8 ページ。

Installation

INSTALLATION:

01. Remove the protection grille (fig. 7-A) and the cover (fig. 7-B) to open the housing;

02. Unhook the side hook so that the body of the control unit can be rotated (fig. 8);

03. Insert the memory board supplied; ensure that it is correctly inserted in the internal

connector guides (fig. 9). On control unit models HSCU1GC and HSCU1G (with GSM) also insert

the SIM card (fig. 10).

04. Before fixing the housing, the "anti-lever" system can be activated if required on the rear

tampering detector (fig. 11): a) remove part "a" as shown and set aside b) remove part "b" as

shown and throw it away;

05. For models HSCU1GC and HSCU1C: make a hole for the cables (fig. 12) and route the

electric power cables through the hole (fig. 13);

06. Refit the control body unit in its seat (fig. 14);

07. Mark the 3 fixing points shown in fig. 15 on the wall. If the "anti-lever" system has been

activated also mark the 4th point for part "a" (fig. 15);

08. Drill holes in the wall at the 3 fixing points and insert the screws and plugs supplied (fig.

16). If the "anti-lever" system has been activated also drill a hole at the 4th point and insert the

plug and part "a", previously set aside (fig. 16)

09. Fix the control unit to the wall using the screws supplied (fig. 17);

10. Electrical connections: • For models HSCU1GC and HSCU1C: make the electrical connections

and insert the buffer battery as described in chapter 5. • For models HSCU1G and HSCU1:

connect the battery pack as shown in fig. 18;

11. Close the housing (fig. 19). 12. Now proceed with the installation of the various devices as

envisaged

Visit our website: www.Alloremotecontrol.com