- ページ 17

DJ機材 Dialighting IW19-10 ZOOMのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dialighting IW19-10 ZOOM 20 ページ。

5. Troubleshooting

Following are a few common problems that may occur during operation. Here are some

suggestions for easy troubleshooting:

A. The unit does not work, no light and the fan does not work

Check the connection of power and main fuse.

Measure the mains voltage on the main connector.

Check the power on LED.

B. Not responding to DMX controller

DMX LED should be on. If not, check DMX connectors, cables to see if link properly.

2. If the DMX LED is on and no response to the channel, check the address settings and DMX

polarity.

If you have intermittent DMX signal problems, check the pins on connectors or on PCB of

the unit or the previous one.

Try to use another DMX controller.

Check if the DMX cables run near or run alongside to high voltage cables that may cause

damage or interference to DMX interface circuit.

C. One of the channels is not working well

The stepper motor might be damaged or the cable connected to the PCB is broken.

The motor's drive IC on the PCB might be out of condition.

The cleaning must be carried out periodically to optimize light output. Cleaning frequency

depends on the environment in which the fixture operates: damp, smoky or particularly dirty

surrounding can cause greater accumulation of dirt on the unit's optics.



Clean with soft cloth using normal glass cleaning fluid.



Always dry the parts carefully.



16D