- ページ 3
ゲートウェイ Dialogic 2000 Media Gateway SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dialogic 2000 Media Gateway Series 4 ページ。 Guide for microsoft office communications server 2007
ページを印刷する
Setting T1/E1 Parameters
Navigate to: Configuration > TDM > T1/E1 and adjust the following settings -
1. Set Telephony Port Interface Side: This should be Terminal if your PBX is set to Network or Network if your PBX is set to Terminal.
2. Set line Encoding and framing: This should match your PBX settings.
3. Click Submit to save settings. This will prevent loss of configuration. Do not restart the gateway.
Navigate to: Configuration > TDM > General and adjust the following settings -
1. Set PCM Coding: uLaw or aLaw to match your PBX setting.
2. Click Submit to save settings. This will prevent loss of configuration. Do not restart the gateway.
Setting Microsoft
Office Communications Server 2007 Specific Parameters
®
Navigate to: Configuration > VoIP > General, and adjust the following setting -
1. Set Transport Type: TCP.
2. Click Submit to save settings. This will prevent loss of configuration. Do not restart the gateway.
Navigate to: Configuration > VoIP > Media, and adjust the following settings -
1. Set Audio Compression: G.711u or G.711a to match your Microsoft
2. Set Signaling Digit Relay Mode: Off.
3. Set Voice Activity Detection: Off.
4. Set fax IP-Transport Mode: G.711-Passthrough.
5. Click Submit to save settings. This will prevent loss of configuration. Do not restart the gateway.
Navigate to: Configuration > IP, and adjust the following setting -
1. Set BOOTP Enabled: No.
2. Click Submit to save settings. This will prevent loss of configuration. Do not restart the gateway.
Set Transport Type: TCP
Office Communications Server 2007 setting.
®
Set Audio Compression: G.711u or
G.711a to match your Microsoft
Communications Server 2007 setting
Set Signaling Digit Relay Mode and
Voice Activity Detection: Off
Set fax IP-Transport Mode: G.711
Passthrough
Set Telephony Port Interface Side to
Network or Terminal, using the opposite
setting from your PBX setting
Set line Encoding and framing to match
your PBX settings
Set PCM Coding: uLaw or aLaw to
match your PBX setting
Office
®
Set BOOTP Enabled: No