- ページ 7

ゲートウェイ Dialogic IMG 1004のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dialogic IMG 1004 10 ページ。 Integrated media gateway
Dialogic IMG 1004 にも：クイック・スタート・マニュアル (10 ページ), クイック・スタート・マニュアル (8 ページ)

ページを印刷する

Connecting and Configuring Network Management Port

'CTRL'

The information below will provide the user with a basic setup sequence for connecting and

configuring the IMG 1004 along with the GCEMS server to download system software and

start configuring the IMG 1004 using the ClientView GUI. On the rear of the IMG 1004 are

the network interfaces. The first interface -CTRL - is a Fast Ethernet port dedicated to

network management. This port is connected to the GCEMS server and allows the GCEMS

server to access the IMG 1004.

1. Connect up the cables as shown in the first figure below.

2. Once the cables are connected, configure FTP and DHCP on the GCEMS server. Locate the

MAC address which is printed on a label located on the rear panel of the IMG 1004. This

will be used in the dhcpd.conf file creation.

For more information on how to set up the services above refer to the topics under the

following sections in the online documentation

IMG 1004-Installation and Setup Guide > IMG 1004-Software Installation and Setup

If setup requires using an SD card to load system software refer to the topics under the IMG

1004-SD Card heading below in Online Documentation.

IMG 1004-Installation and Setup Guide > IMG 1004-SD Card

Index