- ページ 14

ゲートウェイ Dialogic IMG 1010のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dialogic IMG 1010 18 ページ。 Connecting dc power
Dialogic IMG 1010 にも：取付説明書 (6 ページ), クイック・スタート・マニュアル (11 ページ), クイック・スタート・マニュアル (10 ページ), クイック・スタート・マニュアル (10 ページ), 取付説明書 (9 ページ), クイック・スタート・マニュアル (4 ページ)

IMG 1010 Quick Start Guide

Create symbolic link to load system software

To install the System Software into the IMG, the FTP Server being utilized (Usually GCEMS

Server) should have one of two things to allow software to be loaded.

•

A pathname to the specific software that is to be installed -or-

•

Have a link generated in the ftp server that points a generic name

(img1010_id0101.bin) to a specific software file.

The procedure below describes the latter. Creating a link will allow the user to change

software builds in the IMG easily. The link generated will create an association between the

filename line in the dhcpd.conf file located in /etc and the latest version software being

installed. The link will be created in the /home/excelsw/ftpBuilds folder. A script has been

written that will create the symbolic link described above. This script was written to make it

easier to change the symbolic link each time a new build is to be installed. Follow the

procedure below to create the symbolic link through the lnimg script.

1. Copy the script file labeled lnimg located in the /opt/dialogic/common/osconfig

directory and paste it into the /home/excelsw/ftpBuilds directory.

2. From the ftpBuilds run the lnimg (link img) script

[root@localhost]# ./lnimg

3. Follow the instructions and enter the appropriate IMG 1010 Build Number from the

Available IMG 1010 Build files. Use the format described in the lnimg script.

(1051=10.5.1, 1052=10.5.2, 1053=10.5.3).

4. The following response will be generated:

Link Created... img1010_ver1053123_id0101.bin -> img1010_id0101.bin

5. Executing the ls –la command as shown above, verifies that the link was created.