- ページ 9

ゲートウェイ Dialogic IMG 1010のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dialogic IMG 1010 10 ページ。 Connecting dc power
Dialogic IMG 1010 にも：取付説明書 (6 ページ), クイック・スタート・マニュアル (11 ページ), クイック・スタート・マニュアル (18 ページ), クイック・スタート・マニュアル (10 ページ), 取付説明書 (9 ページ), クイック・スタート・マニュアル (4 ページ)

Connecting TDM Signaling and Bearer Ports



The Bearer ports (Interface Offsets) 0-27 are connected to the TDM network. Each Bearer

Port can have signaling and bearer channels configured on it.



The Signaling/Timing Ports are connected to the TDM network, and can also be used for

signaling and bearer traffic the same as the Bearer ports. See the 'T1/E1' under the

'Configuration' section in the online help for more information.



SS7 Signaling links and ISDN D-channnels can be brought in over either the

Signal/Timing Ports or the Bearer Ports. See 'signaling' under the 'Configuration' section

in the Online Documentation for more information.

Once the IMG 1010 has software installed, the cabling is connected, and the GCEMS server

has been configured, the ClientView application can be used to configure the system. Below

are a few topics from the Online Documentation to get you started on configuring the IMG

1010 through the ClientView GUI



Configuration > ClientView > (All topics under this book)



Configuration > Introduction



Configuration > Node Configuration Wizard



Configuration > Basic Configuration

From here you are ready to configure the IMG 1010 for your network. Use the Online Manual

Configuration, Clientview, and ClientView Pane sections to configure the IMG 1010.

Dialogic Corporation

IMG 1010 Quick Start Guide

Part # 07-8728-03

Page 9 of 9