- ページ 2

滅菌器 AllPondSolutions CUV-136のPDF マニュアルをオンラインで閲覧またはダウンロードできます。AllPondSolutions CUV-136 17 ページ。 Pond & aquarium uv steriliser

To ensure your UV Steriliser is set up and running correctly, and to prevent any

accidental damage or injury, please read and follow the below instructions

carefully before using your product.

SAFETY

IMPORTANT!

Disconnect the mains electricity supply before attempting any

installation / maintenance of any kind. Do not attempt to modify this unit in

any way and only use the recommended parts for replacement.

The CUV steriliser should never be submerged as this will cause

permanent damage to the unit.

All connections must be earthed.

The power cord of this appliance cannot be replaced; if the cord is

damaged, the appliance should be discarded. Never cut the cord.

Do not connect to any voltage other than that stated.

Do not use with liquids other than water.

Do not use with water above 90F or 30C.

Do not carry or pull the unit by its electrical cable.

Do not use this unit if it has a damaged cord, if it is malfunctioning or it is

dropped or damaged in any manner.

Do not attempt to modify this unit in any way and only use attachments and

the recommended parts for replacement recommended by the

manufacturer.

Before installing, maintaining or handling your equipment, or before placing

your hands in your pond, ensure that the unit is disconnected from the

electricity supply.

Always disconnect any electrical devices when not in use.

Carefully examine your pond system after installation. Do not connect the

unit to the mains if there is water on any parts not intended to be wet.

Do not look directly at the UV light when it is operational.

Before operating your CUV system observe that water is ﬂowing through it

- the UV requires constant ﬂow to avoid overheating.