- ページ 6
芝刈り機 ALLPOWER SupaSwift 645 BIG BOBのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ALLPOWER SupaSwift 645 BIG BOB 10 ページ。 18”, 21”
ページを印刷するENGINE STARTING PROCEDURE
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
1.
Fill the engine with fuel and oil as per the engine manufacturer's instructions.
2.
Ensure catcher is fitted correctly (
3.
Check the height adjustment is set correctly for the mowing conditions you are about to encounter
(
refer to OPERATING PROCEDURE
4.
Start the engine in accordance with the engine manufacturer's instructions.
5.
Allow the engine to warm up for several minutes.
6.
Run the engine at maximum throttle setting.
7.
NB. Some models may have a fixed throttle. Please refer to the engine owners
manual for the configuration of your machine.
1.
Adjust the throttle control to the slow position.
2.
Switch the engine off.
Allow all moving parts to come to a complete stop before transporting or storing the unit.
The Supaswift Lawn Mower has 12 height positions. Positions are indicated
by the holes in the Quadrant plate (1) which mesh with the pin on the height
adjuster leaver (2). Position 1 is a travel position and must not be used for
mowing. In this position the mower blades are too low to cut grass and
damage may result. Please refer to the table below for more information.
Tip: Remember grass is a living plant and requires its leaves to live.
The leaves are what you cut and by cutting too low can result in killing
of your grass and a poor finish. This can also cause premature wear
and damage to your lawn mower.
RESULT DESIRED
1.5cm
2cm
2.5cm
3.5cm
3cm
refer to OPERATING PROCEDURE
).
SHUTTING DOWN THE MACHINE
HEIGHT ADJUSTER POSITION
HEIGHT ADJUSTMENT TABLE
HEIGHT ADJUSTER
POSITION
2
3
4
7
6
CAUTION: Read the Engine Manufacturers
Operators Manual for detailed starting
instructions
).
RESULT DESIRED
4cm
4.5cm
5cm
5.5cm
6cm
Image 4
HEIGHT ADJUSTER
POSITION
8
9
10
11
12
P a g e
| 6