- ページ 11
スイッチ ALLREDI MARCO 151EのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ALLREDI MARCO 151E 16 ページ。 Remote control switch
ページを印刷する
W-562
Always depressurize
the entire system,
disconnect all power
sources and lockout/
tagout all components
before any maintenance
or troubleshooting is
attempted. Failure to
comply with the above
warning could cause
electrical shock and
inadvertent activation of
equipment resulting in
death or serious injury.
N-516
Pulling and dragging
abrasive blasting hose
may cause control
line and electric cord
connections to separate.
Connect the control line
and electrical cord to
the abrasive blasting
hose every 4 to 6 feet
and on each side of the
control line connections.
Provide adequate slack
at each connection.
Use a 16 gauge electric
cord for lengths up
to 300 feet. To reduce
electrical resistance, use
larger gauge electrical
cord for distances
greater than 300 feet.
INSTALLATION
Marco
151E Remote Control Switch
®
1
Installation
1) Install Electric Connector (1) on to Electric Control Line (2) of Remote Control
Switch (3).
2) Place Remote Control Switch (3) on Abrasive Blasting Hose (6) behind Nozzle
Holder (4).
3) Place Nylon Band (5) on front of Remote Control Switch (3). Do not tighten Band
completely.
4) Place Nylon Band (5) on rear of Remote Control Switch (3). Do not tighten Band
completely.
5) Adjust location of Remote Control Switch (3) to a comfortable position on Abrasive
Blasting Hose (6) and tighten Nylon Bands (5) to secure the Switch Assembly to the
Abrasive Blasting Hose. Cut off excess tail of Nylon Bands.
6) Secure Electric Control Line (2) to Abrasive Blasting Hose (6) every 4 to 6 feet, and
on each side of the hose connections. Provide adequate slack at each connection.
2
3
6
5
Marco
4
5
151E Remote Control Switch
®
10