- ページ 6

溶接システム Miller 059015056のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller 059015056 44 ページ。

ページを印刷する
Miller 059015056 オーナーズマニュアル
EMF DATA SHEET FOR ARC WELDING POWER SOURCE
Product/Apparatus Identification
Compliance Information Summary
Applicable regulation
Reference limits
Applicable standards
Intended use
Non−thermal effects need to be considered for workplace assessment
Thermal effects need to be considered for workplace assessment
Data is based on maximum power source capability (valid unless firmware/hardware is changed)
Data is based on worst case setting/program (only valid until setting options/welding programs are changed)
Data is based on multiple settings/programs (only valid until setting options/welding programs are changed)
Occupational exposure is below the Exposure Limit Values (ELVs)
for health effects at the standardized configurations
Occupational exposure is below the Exposure Limit Values (ELVs)
for sensory effects at the standardized configurations
Occupational exposure is below the Action Levels (ALs) at the
standardized configurations
EMF Data for Non-thermal Effects
Exposure Indices (EIs) and distances to welding circuit (for each operation mode, as applicable)
Standardized distance
ELV EI @ standardized distance
Required minimum distance
Distance where all occupational ELV Exposure Indices fall below 0.20 (20%)
Distance where all general public ELV Exposure Indices fall below 1.00 (100%)
Tested by:
Joe Krueger
XXXXXX‐A
Product
MigMatic S500i
MigMatic S400iP
Migmatic S400i
Directive 2014/35/EU
Directive 2013/35/EU, Recommendation 1999/519/EC
IEC 62822−1:2016, IEC 62822−2:2016
for occupational use
Sensory
Effects
10 cm
0.08
1 cm
for use by laymen
(if NO, specific required minimum distances apply)
n.a
(if applicable and NO, specific measures are needed)
n.a
(if applicable and NO, specific signage is needed)
Head
Health
Trunk
Effects
10 cm
10 cm
0.06
0.09
1 cm
1 cm
Date tested:
2019−12−06
Stock Number
059015056
059015055
059015054
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
Limb (hand)
Limb (thigh)
3 cm
3 cm
0.05
0.11
1 cm
1 cm
2 cm
82 cm