産業機器 ABB DODGE COOL LUBE 2のPDF 使用方法をオンラインで閲覧またはダウンロードできます。ABB DODGE COOL LUBE 2 4 ページ。

DODGE COOL LUBE 2 for Mounted Roller Bearings

These instructions must be read thoroughly before installation or operation. This instruction manual was accurate at the time of

printing. Please see baldor.com for updated instruction manuals.

Note! The manufacturer of these products, Baldor Electric Company, became ABB Motors and Mechanical Inc. on

March 1, 2018. Nameplates, Declaration of Conformity and other collateral material may contain the company name of

Baldor Electric Company and the brand names of Baldor-Dodge and Baldor-Reliance until such time as all materials have

been updated to reflect our new corporate identity.

WARNING: To ensure the drive is not unexpectedly

started, turn off and lock-out or tag power source before

proceeding. Failure to observe these precautions could

result in bodily injury.

WARNING: All products over 25 kg (55 lbs) are noted on the

shipping package. Proper lifting practices are required for

these products.

WARNING: Only qualified personnel familiar with hydraulic

and electrical installations, the construction and operation

of this equipment, and the hazards involved should install,

adjust, operate, and/or service it. Read and understand

this manual in its entirety before proceeding. Failure to

observe this precaution could result in severe bodily injury

or loss of life.

WARNING: Because of the possible danger to person(s) or

property from accidents which may result from the improper

use of products, it is important that correct procedures be

followed. Products must be used in accordance with the

engineering information specified in the catalog. Proper

installation, maintenance and operation procedures must

be observed. The instructions in the instruction manuals

must be followed. Inspections should be made as necessary

to assure safe operation under prevailing conditions. Proper

guards and other suitable safety devices or procedures as

may be desirable or as may be specified in safety codes

should be provided, and are neither provided by ABB nor

are the responsibility of ABB. This unit and its associated

equipment must be installed, adjusted and maintained by

qualified personnel who are familiar with the construction

and operation of all equipment in the system and the

potential hazards involved. When risk to persons or property

may be involved, a holding device must be an integral part

of the driven equipment beyond the speed reducer output

shaft.

Part Numbers 063485, 063486, 078327, 078328

System Specifications:

System

Part

Motors Information

Number

063486

Single Phase—115/230 VAC

063485

Three Phase—230/460 VAC

078327

Three Phase—208-230/460 VAC

(Explosion Proof Motors)

078328

Three Phase—575 VAC (Canada)

Note: For Cool Lube 2 material details, please refer to cut

sheets.

Air to oil heat exchanger:

* Pump Relief valve setting:

* Bearing Relief valve setting:

Pump ﬂow rate:

Flow meter range:

Oil supply line connection:

Oil return line connection:

* Relief valves are preset at the factory, but are field

adjustable. If other settings are required, consult Dodge

Engineering

Approximate

Weights (lbs.)

257

Thermal Transfer BOL-8-2

150 psi

65 psi

2 GPM

0.05 – 0.5 GPM

Two 1/4" NPT connections at

the ﬂow meter outlets (female)

Two 1" NPT connections

(female)