- ページ 29

溶接システム Miller XMT 450 CVのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller XMT 450 CV 48 ページ。 With arcreach

ページを印刷する

6-2.

Mode Switch Settings

Switch Position

WIRE - Gas

MAW

WIRE - Gas*

WIRE - No Gas*

STICK EXX18*

STICK EXX10*

GOUGE*

Lift-Arc TIG*

TIG

*An ArcReach device will override any control connected to remote 14-pin receptacle.

**See Section 9-4 Alternate Configuration Functions

6-3.

Associating ArcReach Device To ArcReach Power Source

Quick Setup Guide:

1 Make connections between power source and ArcReach device. (See section pertaining to mode being used for typical connection

diagrams).

2 This power source has the ability to associate with an ArcReach device at power up, or when an ArcReach wire feeder is triggered. The

Mode Switch on this power source must be set to an "OUTPUT ON" mode to associate with another ArcReach device.

3 See instructions in the owner's manual for the specific ArcReach device to associate the device to this power source.

4 During the association process the Remote in Use indicator will blink.

5 When the association process is complete, the Remote In Use indicator will be lit. Dependent on the capabilities of the ArcReach device;

the mode switch, voltage/amperage adjustment, and Arc Control adjustment may be overridden by the ArcReach device.

Process

Output Control

GMAW

Remote 14

FCAW

GMAW

Electrode Hot

FCAW

FCAW-S

Electrode Hot

SMAW

Electrode Hot

SMAW

Electrode Hot

CAC-A

Electrode Hot

GTAW

Electrode Hot

GTAW

Remote 14

Panel Adjust

Remote 14

Adjust

Volts

Amps

% Panel Amps**

Amps

% Panel Amps**

Amps

% Panel Amps**

Amps

% Panel Amps

Amps

% Panel Amps

ArcReach

Adjust

- -

Volts

Amps

- -

OM-292663 Page 25