- ページ 19

溶接システム Miller XR-15WのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller XR-15W 36 ページ。 With quick disconnect ce, 200/400 ampere air/water push-pull welding gun

ページを印刷する
Miller XR-15W オーナーズマニュアル

5-10. Threading Welding Wire Through Gun

!
Welding wire is electrically live when gun trigger
is used to jog wire.
.
Turn OFF coolant supply before removing head tube
on water-cooled gun.
1
Pressure Roll Assembly
Lift arm and open pressure roll assembly.
2
Cable Assembly
Lay cable assembly out straight.
Push Jog switch up to feed wire through cable assembly.
3
Drive Roll
For wire sizes .035 in. (0.9 mm) and smaller use small
Feed wire to check drive roll pressure.
If necessary, slightly tighten thumb nut
inside gun.
Tools Needed:
5
JOG / PURGE
2
WOOD
.
Refer to Section 5-6 for instructions on feeding wire
through feeder.
3
1
4
groove, and .047 in. (1.2 mm) and 1/16 in. (1.6 mm) use
large groove.
4
Contact Tip
Manually thread wire along drive roll groove and out con-
tact tip 2 in. (51 mm). Close pressure roll assembly.
5
Tension Thumbnut
6
Pressure Adjustment Knob
7
Final Pressure Adjustment
See procedure at bottom of page. Reinstall gun cover.
Cut off wire. Close and latch wire
feeder door.
Ref. 246 218-A / 151 599-F / 250 982-A / 250 981-A
6
OM-236297 Page 15