- ページ 8

カメラアクセサリー aquantica at2iのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。aquantica at2i 16 ページ。 For the canon t2i

Important Note: prior to installing the camera in the housing: Please remove the rubber protective guard from the viewﬁnder

on your camera, remove the camera strap and/or any object that might obstruct installation or get in the way of that attach the

strap should be removed or tucked away

Pull the lens lock lever (key # 12) on the front of the housing outward and the mode dial knob up (key # 04)

If installing the camera with a lens attached, pull out the Focus/Zoom control knob ( key # 08) and rotate

its collar disk (key # 09) into the upper position, this will move the pinion gear (Key # 10) out of the way.

Remove the saddle from the housing and carefully place the camera on it and ensure

the camera is properly installed and aligned as follows:

a) Align the Tripod Socket of the camera with the mounting screw. Tighten the mounting screw

securely while ensuring that the camera position is not altered as per drawing at right.

c) position the ON / OFF (key # 03) in the OFF position and do the same to the camera.

d) Important: if using optical ﬁber type cords, remember to eventually pop the ﬂash up and test it.

e) Slide the quick release tray back into place and lock as per drawing at right.

CLOSING OF THE HOUSING

Once the camera is secure on the saddle inside the front half of the housing, simply:

(if using wired strobes on the bulkhead connectors on the housing, you will require the

hot shoe to be mounted on the hot shoe base of the camera, as seen in photo at right.

Before closing the housing always ensure that:

The main O-ring on the front half of the housing is clean,lubricated and properly seated for a positive seal.

The sealing surface on the rear half of the housing is clean and free from any scratches or physical damage.

All cords or wires are tucked in so that they do not interfere with the closing of the housing.

The levers are in the proper position on both the camera and the housing .

To close the housing simply:

Join the front and rear halves of the housing using the two dowel pins at the bottom of the housing as a guide.

ii.

Hold the housing with both hands and look around the sealing surface to ensure that the O-ring remained properly seated and

that no cords, wires are caught between the edges.

iii.

Close the two sides latches simultaneously. Simply reverse the process to open housing

CAUTION: if you feel any resistance as you attempt to close the latches, do not force the closure. open the housing

and check for any obstruction and try again.

iv.

Verify that the secondary safety locking mechanisms of the latches are properly engaged to avoid any accidental opening.

CAMERA PREPARATION AND INSTALLATION

WARNING

page 7