- ページ 26

溶接システム Miller XT30のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller XT30 40 ページ。 Air plasma cutting and gouging
Miller XT30 にも：オーナーズマニュアル (44 ページ)

6-3. Trigger Safety Lock

Trigger Locked

Always connect work clamp to a clean,

paint-free location on workpiece, as close to

cutting area as possible.



Maintain approximately a 90

workpiece surface for proper cutting results.

1/16 in.

(1.6 mm)

When doing extended (non-shielded)

cutting, maintain approximately 1/16 in.

standoff between electrode and surface.

OM-253 555 Page 22

A complete Parts List is available at www.MillerWelds.com

Sparks should pass through the workpiece



angle to the

and out the bottom when cutting.

DO NOT put pressure on shield when

drag cutting; instead, slide shield along

the surface for proper cutting results.

Trigger Unlocked

DO NOT start pilot arc without cutting or

gouging as this shortens the service life

of the nozzle and electrode.

Trigger

The pilot arc starts immediately

when trigger is pressed.

If sparks flare back from surface, this

usually is an indication that either travel

speed is too fast or amperage is set too low.

Pulling rather than pushing the torch

makes cutting easier. Use a proper guide

or template for accurate cutting operations.

Ref. 253554-A

Ref. 254 087-A