- ページ 29

溶接システム Miller XT30のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller XT30 44 ページ。 Air plasma cutting and gouging
Miller XT30 にも：オーナーズマニュアル (40 ページ)

6-5.

Sequence Of Cutting Operation

A complete Parts List is available at www.MillerWelds.com

�

Complete Parts List is available at www.MillerWelds.com

Ref. 254087-A

The pilot arc starts immediately

when trigger is pressed.

Step 1. Connect work clamp to a clean,

paint-free location on workpiece, as close to

cutting area as possible.

Step 2. For standard (shielded) cutting,

place drag shield on edge of metal. For ex-

tended (non-shielded) cutting, use 1/8 in.

(3.2 mm) standoff distance (dragging tip will

reduce tip life).

Step 3. Raise trigger lock and press trigger.

Pilot arc starts.

Step 4. After cutting arc starts, slowly start

moving torch across metal.

Step 5. Adjust torch speed so sparks go

through metal and out bottom of cut.

Step 6. Pause briefly at end of cut before re-

leasing trigger.

Step 7. Postflow continues for approximately

20 seconds after releasing trigger; cutting

arc can be instantly restarted during postflow

by raising trigger lock and pressing trigger.

OM-253555 Page 1

OM-253555 Page 25