- ページ 22
溶接アクセサリー Miller 24AのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller 24A 40 ページ。 Wire feeder
ページを印刷する5-7. Motor Start/Burnback Control
Tools Needed:
Non-Conductive
1/4 in.
Notes
OM-193472 Page 18
1
2
3
To change wire feed starting speed
proceed as follows:
Turn Off unit and welding power
source.
Remove wrapper.
1
Motor Board PC1
2
Motor Start Control
Potentiometer R73
Remove protective white rubber
cap before making adjustment.
Adjust potentiometer R73 using a
small nonconductive screwdriver.
Rotate potentiometer clockwise to
increase time it takes the motor to
ramp up to speed.
3
Burnback Potentiometer R42
Remove protective white rubber
cap before making adjustment.
Adjust potentiometer R42 using a
small nonconductive screwdriver.
Rotate potentiometer clockwise to
increase burnback time.
Reinstall wrapper.
Ref. 802357 / 240357-D