- ページ 25
溶接アクセサリー Miller ArcReach SuitCase 12のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller ArcReach SuitCase 12 48 ページ。
ページを印刷する
DIP Switch Settings (continued):
Display Amperage − Set switch 2 so the depressed section is toward OPEN as labeled on the switch.
Wire Speed / Amps Display will display Amps while welding and Wire Speed while not welding. If the hold func-
tion is enabled, Amps will be displayed during hold also.
Do Not Display Amperage (Factory Default) − Set switch 2 so the depressed section is toward 2 as labeled
on the switch.
Wire Speed / Amps Display will display only Wire Speed.
Wire Speed - Meters Per Minute − Set switch 3 so the depressed section is toward OPEN as labeled on the
switch.
Displays Wire Speed in Meters per Minute.
Wire Speed - Inches Per Minute − Set switch 3 so the depressed section is toward 3 as labeled on the switch.
Displays Wire Speed in Inches per Minute.
Wire feeds during ArcReach association (Factory Default) − Set switch 4 so the depressed section is toward
4 as labeled on the switch.
This will allow wire to feed when the trigger is pulled and the association process is taking place.
This mode must be used when the feeder is not expected to associate with an ArcReach control, or an ArcReach
compatible welding power source. This could be when using a non-ArcReach compatible power source or if the
feeder CC/CV switch is set to CC mode.
Wire does not feed during ArcReach association − Set switch 4 so the depressed section is toward OPEN
as labeled on the switch.
This will prevent wire from feeding when the trigger is pulled and the association process is taking place.
Display Feeder Information − Set switch 5 so the depressed section is toward OPEN as labeled on the switch.
With switch in ON position, at feeder power up, feeder will display various sets of information. Each set of infor-
mation will be displayed for three seconds.
Display Board (PC22) Software Part Number −
Top display will show the first three digits, bottom display will show last three digits of the Display board (PC22)
software revision level.
Motor Board (PC1) Software Part Number −
Top display will show the first three digits, bottom display will show last three digits of the Motor board (PC1)
software revision level.
Accumulated Weld Time −
This is the time the feeder has actually been used for welding. This information will be displayed in two halves.
First half being years (top display) and days (bottom display), second half is hours (top display) and minutes
(bottom display).
Do Not Display Feeder Information (Factory Default) − Set switch 5 so the depressed section is toward 5
as labeled on the switch.
Feeder information is not displayed.
Ref. 257 794-A
OM-278792 Page 21