- ページ 32
溶接アクセサリー Miller ArcStationのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller ArcStation 44 ページ。
Miller ArcStation にも： オーナーズマニュアル (20 ページ)
ページを印刷する
M. Installing Stiffener Brackets And Work Lead Tab
3
DD
Tools Needed:
hex bit 3/16 in.
N. Grounding The Welding Table
OM-244 997 Page 28
Rear
2
2
Top View
EE and ZZ
1
EE and ZZ
1/2 in.
2
2
EE and ZZ
2
1
Tools Needed:
hex bit 3/16 in.
.
To level the 60S or 60SX,
adjust leveling feet for the
center subframe first. Then
adjust leveling feet for the end
subframes.
After setting the welding table in
place, make final adjustments to
leveling feet keeping the tops level
and the feet solid on the floor.
Tighten jam nuts on feet at this time.
1
Stiffener Brackets
Use three bolts EE and three
locknuts ZZ and install two cross
members to rear of center and end
subframes.
2
Tapped Holes For Work Lead
Tab
3
Work Lead Tab
Attach work lead tab with one bolt
DD to bottom side and at the rear of
the tops using any one of the four
tapped holes.
1
!
Connect welding table to a
good
electrical
ground
(independent of the welding
leads)
unless
a
qualified
person assures it is safe to
work
on
an ungrounded
workpiece.
1
Ground Bolt
2
Tapped Hole For Ground Bolt
Use the supplied ground bolt to
connect the welding table to a good
electrical ground according to
national, state, and local codes.