- ページ 10
溶接アクセサリー Miller Spoolmatic 30AのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller Spoolmatic 30A 32 ページ。 Welding guns
Miller Spoolmatic 30A にも： オーナーズマニュアル (32 ページ), オーナーズマニュアル (36 ページ)
ページを印刷する
4-1. Unit Specifications
Approximate
Wire Diameter
Wire Feed
Range
Range
.025 Thru 1/16 in.
(0.6 Thru 1.6 mm)
Aluminum Wire
70 To 875 ipm
(1.7 To 22.2
.025 Thru .045 in.
mpm)
(0.6 Thru 1.1 mm)
Hard Or Cored Wire
4-2. Environmental Specifications
A. IP Rating
B. Temperature Specifications
Operating Temperature Range
14 to 104 °F (−10 to 40°C)
.
Use weld control or welding power source Owner's Manual during gun installation. If contact tip, liner, and drive roll groove are not correct for wire
size and type, see Section 7 to change parts as needed. See Parts List for other available contact tips.
5-1. Removing Top Cover
OM-1213 Page 6
SECTION 4 − SPECIFICATIONS
Cooling
Maximum
Method
Spool Size
4 in. (102 mm)
Air Cooled
Diameter
This equipment is designed for outdoor use.
SECTION 5 − INSTALLATION
1
Weld Circuit Rating
100 Volts, 200 Amperes,
100% Duty Cycle
Using Argon Shielding Gas
IP Rating
IP23
Storage Temperature Range
−4 to 131 °F (−20 to 55°C)
Overall
Weight
Dimensions
2.9 lb
(1.3 kg) Gun
Length: 15-3/8 in.
Only
(390 mm)
Width: 2-1/2 in.
15A Model:
(64 mm)
9 lb (4.1 kg)
Height: 10-3/4 in.
Gun With Cable
(273 mm)
30A Model:
14 lb (6.4 kg)
Gun With Cable
IP23 2017−02
Temp_2016- 07
1
Top Cover Triangular Boss
Push up on triangular boss to open
door. Door hinges on handle.
To open door fully, push up on door
until it clicks into position.
.
If door is pushed too far it will
separate from handle. If this
happens the door can be rein-
stalled.
Push door back into original posi-
tion to close.
150 882-G