- ページ 16

フィットネス機器 Diamir Experience 06/07のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Diamir Experience 06/07 20 ページ。 Eagle experience freeride pro

14 DIAMIr

Service Manual for specialist dealers

Instruction to the customer

8.1

For optimal use of the binding, the mounting, adjustment to the boot, setting of the skiers DIN value and the service of the ski

binding must be carried out in accordance with the manufacturer's instructions by a specialist dealer. Improper mounting can impair

the bindings function and lead to avoidable injuries.

We recommend having the DIN settings adjusted by the specialist dealer using a ski binding adjustment and testing equipment.

8.2

With the exception of the walking function, there is no difference between this and an alpine binding. Before use, the binding has to

be clean of snow, ice, dirt, etc. in order to assure proper function, especially the walking function.

8.2.1 Step in

to open the automatic heel release system (18) push down the release lever (3) with the ski pole or by hand.

1. remove snow and ice from the boot sole.

2. Centre the tip of the boot in the toe piece (1).

3. Centre the heel of the boot in the automatic heel release system (18) and push it down until it audibly snaps in (Picture 8 A).

the crampons Diamir Axion are shaped asymmetrically; therefore you have a right and a left one. When stepping in with the

boot the according marks need to be taken into consideration.

8.2.2 Step out

to open up the automatic heel release system (18) push down the release lever (3) with the ski pole or by hand (Picture 8 B).

8.2.3 Step in after release of the binding

Position the ski horizontally to the hillside. Open automatic heel release system (18), if needed. Clean the boot sole of snow and ice.

then step in as described in chapter 8.2.1.

8.2.4 Switch to walking mode

1. Unlock the binding with the ski pole or by hand by pulling up the heel elevator (5) one level → 1

2. By changing the position of the heel elevator (5), the angle of the binding can be adapted to the terrain. Lift the binding and push

the heel elevator down with the ski pole or by hand → 2

3. Pull the heel elevator (5) one position up → 3

4. Put the heel elevator (5) to the last position → 4

8.2.5 Switch to skiing mode

1. remove snow and ice from rear support of the heel elevator (5).

2. Put the heel elevator into the first position.

3. Move the end piece of the central rail (4) down to the ski and lock it by pushing down the heel elevator (5) with the ski pole or by

hand (Picture 8 G).

In order to avoid damage of the binding and higher risk of accident, the binding must be locked for descent with the heel

elevator. therefore, crampons must be taken off.

position (Picture 8 D).

position (Picture 8 E).

position (Picture 8 F).

position (Picture 8 C).