- ページ 7
フィットネス機器 Diamir Experience 06/07のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Diamir Experience 06/07 20 ページ。 Eagle experience freeride pro
ページを印刷する
3.2
Mounting
1. Put the rear plate (Eagle / Freeride Pro) together with the heel elevator (5) and position it over corresponding holes and screw it
on tightly with a screwdriver (N° 3; Pozi-Drive).
In order to mount the rear support plate of the model Freeride Pro correctly, first tighten the front screw then the other three
screws of the rear support (Picture 3.2 A).
2. Move the heel elevator (5) up one level. Place the binding on the ski and centre the end piece of the central rail (4) in the heel
elevator (Picture 3.2 B).
3. Screw in the pre-mounted screws of the hinge support (12) half way so that the binding can be adjusted (Picture 3.2 C).
Lift the binding 90° (Experience and Freeride Plus) in order to screw in the two rear screws of the hinge support (Picture 3.2 D).
4. Make sure that the end piece (4) of the central rail is correctly centred in the heel elevator (5). If needed adjust by alignment of the
hinge support and tighten the screws with a tightening torque of max. 5 nm.
5. If there is a protective foil on the vitro don't forget to take it off.
Picture 3.2 a
4
Mounting accessories
4.1
Compatibility of accessories
Only use original Diamir ski brakes and crampons which correspond to the model and to the width of the ski.
the crampons are only for use in hard snow conditions and never on rock or on other hard ground.
ACCESSOrIES
(black /
Axion
(black /
(red /
crampon
(Picture 4.3 C)
Standard
Bag for crampon
(25)
Ski brake
(26)
Safety leash with heel plate
Return spring
l
standard equipment
optional equipment
Picture 3.2 B
ski width till ...
in mm
Picture 4.3
A1)
86
Picture 4.3
A2)
110
Picture 4.3
B)
86
78
100
80
90
100
115
(instead of ski brake)
DIAMIr
Picture 3.2 c
Eagle
Experience
Freeride Pro
—
—
—
—
—
l
l
—
Service Manual for specialist dealers
Picture 3.2 D
—
—
—
l
l
—
www.diamir.com
5