- ページ 4

カメラアクセサリー Miller 1090 Compassx 2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Miller 1090 Compassx 2 13 ページ。 16 cb plus fluid head compassx series

2. Mounting Your Camera

2.1 Remove the CAMERA PLATE by lifting the SAFETY

RELEASE LEVER on the PLATFORM (SLIDE LOCK LEVER

must be unwound (clockwise)) (Fig. 3a).

2.2 Attach the CAMERA PLATE to the camera

the Centre of Gravity (C of G)

approximately in the middle of the camera plate.

2.3 Tighten PAN/TILT LOCKS, mount the CAMERA PLATE

to the PLATFORM non-locking side first. The side load

lock mechanism will capture camera plate (distinct click

sound will be made when CAMERA PLATE is retained).

CAMERA PLATE will be able to slide freely (60mm) until

SLIDE LOCK LEVER is tightened.

2.4 Untighten TILT LOCK, slide the CAMERA PLATE such

that the camera's C of G is directly above the centre axis

of the Fluid Head (fig. 3b), camera should be balanced (if

not slide camera backward or forward). Once balanced

tighten the SLIDE LOCK LEVER (anti-clockwise)

tighten TILT LOCK.

If this cannot be achieved then reposition the CAMERA

PLATE on the Camera – step 2.2.

NOTES:

Refer to the camera's owners manual for correct method of

attachment to the CAMERA PLATE. Remove the 1⁄4" screw

or 3/8" screw as required.

The camera's C of G can be estimated by placing the

camera on to a round rod and then shifting it backwards

or forwards until a balance point – C of G - is achieved. It is

recommended to identify this point on the camera as it will

be useful in step 2.2.

Ensure SLIDE LOCK LEVER is tightened at all times when

you are not finding C of G or mounting/dismounting camera.

such that

mark on the camera is

and

Slide Lock Lever

Safety Release Lever

C of G

Platform

Tilt Lock

Pan Lock

Fig. 3a

Centre Axis

Fig. 3b