- ページ 2

懐中電灯 Miller ICE-25CのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller ICE-25C 38 ページ。 Air-cooled torches for plasma arc cutting

ページを印刷する

Safety Symbol Definitions

DANGER! − Indicates a hazardous situation which, if not

avoided, will result in death or serious injury. The possible

hazards are shown in the adjoining symbols or explained

in the text.

Indicates a hazardous situation which, if not avoided,

could result in death or serious injury. The possible ha-

zards are shown in the adjoining symbols or explained in

the text.

Indicates statements not related to personal injury.

NOTICE

Indicates special instructions.

Beware of electric shock from the cutting torch or wiring.

Touching the cutting torch while in contact with the work

or ground can cause electric shock. Always wear dry

gloves. Keep all panels and covers closed.

Cutting sparks can cause fire or explosion. Move flam-

mables away. Do not cut on closed tanks or barrels −

they can explode. Clean tanks or barrels properly.

Arc rays can burn eyes and skin − wear face protection

(helmet or face shield) with correct shade of filter, and

cover exposed skin with nonflammable clothing.

Hot parts can cause burns. Cutting makes parts very hot

− let them cool before touching.

Allow cooling period. Reduce current or reduce duty cycle

before starting to cut again. Follow rated duty cycle.

Duty Cycle And Overheating

12 Ampere Torch: 35% Duty Cycle At 12 Amperes

25 Ampere Torch: 35% Duty Cycle At 25 Amperes

27 Ampere Torch: 35% Duty Cycle At 27 Amperes

3-1/2 Minutes Cutting

40 Ampere Torch: 50% Duty Cycle At 40 Amperes

80 Ampere Torch: 50% Duty Cycle At 80 Amperes

5 Minutes Cutting

OM-1593 Page 2

6-1/2 Minutes Resting

5 Minutes Resting

Wear safety glasses with side shields.

Cutting processes cause flying pieces of metal and

sparks. Wear a face shield.

Static electricity can damage parts on circuit boards. Put

on grounded wrist strap before touching circuit board.

Have only trained and qualified persons install, operate,

or service this unit. Call your distributor if you do not un-

derstand the directions. For CUTTING SAFETY and EMF

information, read power source Manual.

Beware of moving parts. Keep guards and panels in

place, covers closed, and hands away from moving parts.

Breathing cutting fumes and gases can harm your health.

Cutting requires good ventilation. If ventilation is impossi-

ble, such as when cutting in a confined space, use an

air-supplied respirator.

The plasma arc can cause injury. The intense heat of the

arc or pilot arc can cause serious burns. Keep away from

the torch tip when the trigger is pressed. Do not grip ma-

terial near the cutting path.

Prolonged noise from some cutting applications can dam-

age hearing. Use approved ear plugs or ear muffs if noise

level is high.

Duty Cycle is percentage of 10

minutes that unit can cut at rated

load without overheating.

NOTICE − Exceeding duty cycle

can damage power source and

torch and void warranty.

50 Ampere Torch: 60% Duty Cycle At 50 Amperes

55 Ampere Torch: 60% Duty Cycle At 55 Amperes

6 Minutes Cutting

100 Ampere Torch: 80% Duty Cycle At 100 Amperes

8 Minutes Welding

4 Minutes Resting

2 Minutes Resting

rduty1* 5/95