- ページ 32
懐中電灯 Miller XT30CのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller XT30C 40 ページ。
Miller XT30C にも： マニュアル (40 ページ)
ページを印刷する
6-6. Troubleshooting Torch
Does arc go
on
and
while cutting?
Does arc go out
while cutting?
Do sparks come
out of top of cut;
or cut is not
clean?
Is Trouble light
On; unit has no
cutting output?
Go to Section 6-5.
OM-255 590 Page 28
.
A complete Parts List is available at www.MillerWelds.com
Torch travel speed too slow;
increase travel speed (see
Section 5-2). Clean
Yes
replace torch consumables
off
as necessary (see Section
6-4). Be sure work clamp is
securely
workpiece.
No
Be sure work clamp is
securely attached to work-
piece. Make sure tip is on or
Yes
near, 1/16 in. (1.6 mm) to 1/8
in. (3.2 mm) workpiece (see
Section 5-4). Clean or
replace torch consumables
as necessary (see Section
6-4).
No
Torch travel speed too fast;
reduce travel speed (see
Section 4-1). Clean or
replace torch consumables
Yes
as necessary (see Section
6-4). Be sure work clamp is
securely
workpiece. Unit not capable
of cutting metals thicker
than rating (see Section
4-1).
No
Check torch shield cup (see
Yes
Section 6-2); reset unit
Power switch. *Check torch
and connections inside unit.
No
or
Go to Section 6-5.
attached
to
Go to Section 6-5.
attached
to
Go to Section 6-5.
*Servicing procedure to be performed
only by authorized Service Station.