- ページ 4

安全装置 Miller ShadowLite SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Miller ShadowLite Series 5 ページ。 Beam anchor

TYPICAL WORK-LEVEL AND OVERHEAD INSTALLATIONS

. TRAINING

III

It is the responsibility of the user, and the purchaser, of this equipment to assure that they are

familiar with these instructions and are trained in the proper use, installation, maintenance and limitations of

this product. Training should be conducted periodically and without exposing the trainee to a fall hazard.

. INSPECTION

The Miller ShadowLite™ beam anchor is designed for today's rugged work environments. To

maintain the service life and high performance, the beam anchor should be inspected frequently. Inspect the

unit thoroughly before each use. Regular inspection by a competent person for wear, damage or corrosion

should be a part of your safety program. Inspect your equipment daily and replace it if any of the defective

conditions explained in this manual are found.

When inspecting, check for physical damage, wear, and corrosion. Also check the anchorage

connector and components for damage, cracks, wear, corrosion, or malfunctioning items.

Confirm proper operation/engagement of the ratchet mechanism by sliding the ADJUSTABLE

FOOT back and forth a few times and noting proper operation of the RATCHET RELEASE BUTTON. The

button is spring-loaded and should engage each successive ratchet pocket positively and securely. Dirt and

debris that has become lodged in the ratchet slots of the support shaft, or under the RATCHET RELEASE

BUTTON itself, will prevent safe operation of the unit. See Section V. Maintenance for cleaning details.

A qualified person trained in inspection should keep a log of all inspection dates for this system.

WARNING: Failure of the Ratchet Button Spring will render the Unit

If inspection reveals a defect in condition or operation

REMOVE THE UNIT FROM SERVICE IMMEDIATELY!

MAINTENANCE

A. SERVICING

Servicing must only be carried out by Miller Fall Protection. Only original Miller

replacement parts are approved for use in this device. Contact your Miller distributor or the Miller

Fall Protection Customer Service Department at 1-800-873-5242 if you have any questions.

Note: Beam ends are shown as

an open cross section to better

illustrate proper mounting.

WARNING

Do not mount to

open ended beams.

UNSAFE FOR USE!