- ページ 13

シャワーキャビン Aquapeutics CaribbeanのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Aquapeutics Caribbean 17 ページ。

This wire when

coming from the tub

is 110 volts.

When it comes from

the steam generator

it is 220 volts.

If you have purchased the optional tub water heater the following image and instructions are for you. If you

have not then please skip and disregard this section and you may pick up on the next page.

Pick a side wall water jet pipe that is convenient to work on. Measure the distance taken up by the water

heater. (Approximately 7 and 5/8 inches). Cut this part out. Glue the ends of the water heater and wait until

the glue sets as per the manufactures instructions. Plug the heater in. It has its own thermostatically

controlled on/off and temperature controls. It will turn on when there is water present and the temperature

is below 102degrees and will shut off at 104 degrees. Remember that this heater is plugged into a separate

GFI 110 volt circuit as discussed in two other sections of this manual.

This side is fed and

connected by your

electrician,

110 volts to power

the tub or 220 volts

when energizing

the steam

generator.