- ページ 8

業務用食品機器 Diamond 8046418のPDF 据付・操作・メンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。Diamond 8046418 12 ページ。 Ventilated bain-marie units

8. CLEANING AND MAINTENANCE

8.1 Routine maintenance

The routine and preventive maintenance basically consists in the weekly cleaning of the stainless steel parts with lukewarm soapy water, rinsing

abundantly and drying thoroughly. The unit must only be cleaned after first disconnecting the power supply upstream from the equipment.

Should lime scale form on the bottom of the basin, clean with a vinegar solution or special products before rinsing abundantly with water and drying.

Attention:



Under no circumstances should you use abrasive or corrosive detergents and utensils such as steel wool, brushes or metal scrapers.



Bleach, hydrochloric acid and other compounds containing chlorine will damage the stainless steel.



The coloured parts must be cleaned with silicone wax.



The floor under the unit must not be washed with corrosive substances that might generate vapours damaging the equipment.



During cleaning, do not wash the equipment with jets of water.

8.2 Non-routine maintenance

Special maintenance must be performed by qualified personnel in the event of a fault or anomaly, wherever possible with the equipment

disconnected from the power mains.

In this case, repairs or replacements might be required. The faulty parts must only be replaced with materials and components identical to the

originals or specified by the Manufacturer.

The replacement of components or the modification of the equipment by the user without written permission from the Manufacturer, or the use of non-

authorized spare parts, shall instantly cause the warranty to be void.

8.3 Possible errors

If the BASIN does not heat, check the power supply and make sure the digital temperature regulator is not at the minimum setting.

If, after performing the checks indicated, correct operation is still not achieved, switch off the equipment and contact the supplier without delay.

9. SCRAPPING

At the end of its service life, the equipment must be disconnected from the power mains before disassembling the various components. Special care

must be taken to avoid the risk of accidents associated with the form and weight of each component.

The various parts (electrical components, rubber piping, cable sheaths, etc.) must be selected so as to make the best possible contribution to the

protection of the environment in compliance with the laws in force.

A010336 Rev. 4

Pagina 7 di 11