- ページ 7

屋外噴水 AQUAPHOR CRYSTAL EKO-80-2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AQUAPHOR CRYSTAL EKO-80-2 12 ページ。 Drinking water fountain

AQUAPHOR CRYSTAL EKO-80-2 ユーザーマニュアル
5
FOLLOWING THE WATER FOUNTAIN INSTALLATION AND CONNECTION
In the case of the Crystal EKО-80-2 water fountain:
- open the cold water supply, check the tightness of the device;
- open the clean water tap (5);
- using the water connection (2) (set the handle to the "open tap" position), adjust the
water flow in accordance with the recommended filtration rate of the device;
- let the water run for 10 minutes;
- turn off to clean water tap (5) and wait 10 minutes;
- then run the water again for 50 minutes;
- turn off the tap to clean water (5);
- check the tightness of the connections;
- the fountain is ready for use;
In the case of the Crystal H-80-2 water fountain:
- instead of the KH insert, install a plug (included in the set or may be purchased
separately);
- open the cold water supply, check the tightness of the device;
- open the clean water tap (5);
- using the water connection (2) (set the handle to the "open tap" position), adjust the
water flow in accordance with the recommended filtration rate of the device;
- let the water run for 10 minutes;
- turn off the tap to clean water (5), wait 10 minutes;
- then run the water again for 40 minutes;
Please Note: When draining the water with the cap fitted, check for accidental
leaks.
- put the KH cartridge in the right place and let the water run for another 10 minutes;
- turn the clean water off (5);
- check the tightness of the connections;
- the water fountain is ready for use;