- ページ 6
エアコン Panasonic 3WAY VRF MF2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Panasonic 3WAY VRF MF2 11 ページ。
Panasonic 3WAY VRF MF2 にも： 取扱説明書 (7 ページ)
ページを印刷する
Maintenance
For safety, be sure to turn the air conditioner off and disconnect
z
the power before cleaning. (Otherwise, electric shock or injury may
result because the fan is rotating at high speed.)
Do not pour water on the indoor unit. (This may damage the internal
z
components and cause an electric shock hazard.)
Never use solvents or harsh chemicals. Also, do not wipe plastic parts
z
using very hot water. (This may cause deformation or change in colour.)
Some metal edges and fins are sharp. Be careful when you clean
z
those parts. (Injury may result.)
Use a firm stool or ladder when cleaning an indoor unit installed in
z
high locations.
Tips for Energy Saving
Avoid
Do not block the air intake and outlet of the unit. (If either is obstructed, the unit will not function well, causing
z
malfunction.)
During cooling operation, use sunshades, blinds or curtains to prevent direct sunlight from entering the room.
z
Do
Always keep the air filter clean. (A clogged filter will impair the performance of the unit.) → "Maintenance" (P.6)
z
To prevent conditioned air from escaping, keep windows, doors and any other openings closed.
z
Symptom
The air
conditioner does
not operate
although the
power is turned
on.
Poor cooling
or heating
performance
* Regarding the remote control display, see the page 81.
If your air conditioner does not work properly even after checking each item of
"Before Requesting Services" and "Troubleshooting"
Stop the operation immediately and turn the power off. Then contact your dealer and report the serial number and symptom.
z
You also report if the inspection mark
remote controller.
Never repair the air conditioner by yourself since it is very dangerous for you to do so.
z
6
AMP Air Conditioning
WARNING
CAUTION
Before Requesting Services
Cause
Power failure or after power failure
The operation (power) button is turned off.
Fuse blow out.
The air intake or air outlet of indoor and
outdoor units is clogged with dust.
The fan speed switch is set to "Low".*
Improper temperature settings
The room is exposed to direct sunlight in
cooling mode.
Doors or windows are open.
The air filter is clogged.
Too many heat sources in the room in
cooling mode.
Too many people in the room in cooling
mode.
and the letters E, F, H, L, P in combination with numbers appear on the LCD of the
Indoor unit
(e.g. Type U2)
Wipe with a soft cloth.
(If it is very dirty, use a cloth moistened with water.)
The internal coil and other components of the
z
outdoor unit must be cleaned periodically.
• Consult your dealer or service center.
Action
Press the power ON/OFF button on the remote controller.
• If the breaker is turned off, turn the power on.
• If the breaker has been tripped, consult your dealer
without turning it on.
Contact your dealer.
Remove the dust.
Change to "Medium" or "High".*
See "Tips for Energy Saving". (P.6)
See "Maintenance". (P.6)
Use minimum heat sources and in a short time.
Lower the temperature setting or change to "Medium" or
"High".*
www.ampair.co.uk | [email protected]
Air outlet
Air intake