ページを印刷する4.
ROUTINE MAINTENANCE
Daily hotplate cleaning
Use a standard sprayer to apply the liquid detergent on the whole surface of the cooking
compartment and, using a non-abrasive sponge, clean the entire surface thoroughly by
hand.
When finished, rinse the cooking compartment abundantly with tap water
pressurised and/or direct water
When these operations have been performed successfully, dry the cooking compartment
carefully using a non-abrasive cloth. If necessary, repeat the operations described above
for a new cleaning cycle.
Humidity residue deposited on the hotplate/s can damage the appliance and cause the
hotplate/s to wear quickly.
In order to eliminate all humidity, once routine cleaning has been finished, turn the appliance
on and run it at minimum for approximately 2/3' and then turn it back off (see procedure part 3
Instructions for use: Switching On/Off).
Daily oven cleaning
Depending on the appliance, remove: grills, trays or other objects removed from the
cooking compartment.
Heat up the cooking compartment for about 20'.
Open the door to let the cooking compartment cool off for a few seconds.
Use a standard sprayer to apply the liquid detergent on the whole surface of the cooking
compartment and, using a non-abrasive sponge, clean the entire surface thoroughly by
hand.
When finished, rinse the cooking compartment abundantly with tap water
pressurised and/or direct water
When these operations have been performed successfully, dry the cooking compartment
carefully using a non-abrasive cloth.
If necessary, repeat the operations described above for a new cleaning cycle.
Clean the parts previously removed from the cooking compartment (grills, trays and other
removable objects) with detergent and tap water, rinse them carefully and dry them before
putting them back.
In order to eliminate all humidity, once routine cleaning has been finished, turn the appliance
on and run it at minimum for approximately 20' and then turn it back off (see procedure part 3
Instructions for use: Switching On/Off).
Cleaning for prolonged deactivation
When the appliance remains idle for a long time, perform all the described daily cleaning
procedures.
When the operations are over, protect the parts more exposed to oxidation doing as follows.
•
Use lukewarm water with a bit of soap to clean the parts;
•
Rinse the parts thoroughly, without using pressurised and/or direct water jets;
•
Dry the surfaces carefully using non-abrasive material;
•
Pass over all the stainless steel surfaces using a non-abrasive cloth slightly moistened with
Vaseline to create a protective coating.
For appliances with doors and rubber gaskets, leave the door slightly ajar to let it air out and
spread protective talcum powder on the rubber gasket surfaces.
Air out the appliances and rooms regularly.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
jets).
jets).
- 13 -
13
(do not use
(do not use