- ページ 4

セキュリティシステム chromatec ALARMS-xx SeriesのPDF セットアップマニュアルをオンラインで閲覧またはダウンロードできます。chromatec ALARMS-xx Series 9 ページ。 Remote alarm unit

Chromatec

I ntroduction

The ALARMS-xx is a 1U rack mounting alarm indicator for use specifically with the Chromatec

AM-xx and MADI-xx multi-channel audio meter / alarm systems. It has the facility to visually indicate

the presence of each alarm type for a consecutive group of up to 32 individual audio channels, by

means of front panel mounted LEDs. Additionally, there is an internal audible alarm and provision

for two separate contact closures for remote 'global' alarm signalling. Individual channel pair alarm

reset buttons, plus a single global alarm reset button are provided on the front panel.

I nstallation

ALARMS-xx is equipped with an internal universal AC power supply for mains voltages of 90–240V

AC and is supplied with a suitable IEC power cord. Observe conventional procedures when rack

mounting the unit to ensure adequate support and cooling.

ALARMS-xx Configuration

Each ALARMS-xx unit displays the alarms for 32 channels. Therefore, two units are required to

display the status of all 64 channels of a AM-xx, for example. The set of 32 channels to be displayed

by each ALARMS-xx unit is determined by DIP switch 1 on the back of the frame. If it is OFF (UP)

then alarms from channels 1 to 32 are displayed (and can be reset). If it is ON (DOWN), then alarms

from channels 33 to 64 are displayed.

A set of printed label strips is provided with the ALARMS-xx, so that the channel numbers can be

correctly identified. Select the strips indicating the channel set for which the DIP switch has been set

and apply to the front panel.

Notes:

1) The global reset button resets all alarms in the system (not just the set of 32 that the

frame is set to display).

2) For correct operation, the AM-xx or MADI-xx frame must have V1.11d or later firmware.

If necessary, please contact your Chromatec dealer for an update.

ALARMS-xx

Version 1.0