- ページ 9

配管製品 Aquaport AQP-TAP-4GのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Aquaport AQP-TAP-4G 14 ページ。 Filtered water sink mixer 4 way tap

ページを印刷する

D. Tubing Installation

The Tap has been supplied with quick and easy to install quick

connection pieces for your filtered water connection.

Note: Check the ends of the tubing to make sure there are no

cuts, nicks, flat spots or sharp edges. If any of these are present,

cut the ends with a utility knife. We recommend the use of a

tube cutter.

To install tubing:

Refer to section B. Typical Installation Diagram

1. Measure a length of 1/4" tubing to run from the filter head of

the filtration system to the Quick Connect T Piece.

2. Measure a length of 1/4" tubing to run from one outlet of

the Quick Connect T Piece to the tap Ambient Filtered Water

Connection.

3. Measure a length of 1/4" tubing to run from the other outlet of

the Quick Connect T Piece to the undersink chiller unit inlet.

4. Measure a length of 1/4" tubing to run from the outlet of the

undersink chiller unit to the tap Cold Filtered Water

Shank connection.

5. Measure 3/4 inch (19.05mm) from the ends of the tubing and

mark with a pencil. Fig 2.

6. Push the tubing firmly into the quick connection fittings on

the Filter System, Quick Connect T Piece and Tap connections

until the pencil mark is pushed next to the collet or until tubing

is fully seated, Fig 2. If tubing is removed, re-cut the end,

measure, mark and reinsert.

Note:

Tubing must be fully inserted/seated to avoid leaks.

7. Pull slightly on tubing to ensure tube is secure.

To remove tubing: push collet against the face of the fitting and

pull tubing to remove (with collet still held against fitting face)

Fig 3.

Fig 2

Fig 5 .

3/4"

Correct Cut

(1 9. 05m

19mm

Incorrect Cut

Insert tubing

Fig 3

White collet, do

White Collet

not remove

Do Not Remove

3/4"

Insertion line

Insert 1/4"

_ "

Insertion line

_ "

Tube to Line

19mm

(1 9. 05

mm )

Engagement

3/4" (1/4" Tubing)

Push

Push Collet

Collet

Pull

Pull Tubing

Tubing

INSTALLATION AND OPERATING INSTRUCTIONS 7