ページを印刷する6.1 Troubles during operation
CAUTION: For all the operations described below, disconnect the display cabinet from
the mains and address to specialized personnel who have a sufficient knowledge of the
functions of the different parts and of the precautions to be taken.
Below are listed some possible malfunctioning and the likely cause and remedy. If you cannot
solve the problem or if it is not provided in the following table, call our customer technical
service:
MALFUNCTIONING
The pilot light is off and
the display cabinet is not
refrigerated
The green pilot light is
on
and
the
display
cabinet
is
refrigerated
The orange pilot light is
on
and
the
display
cabinet is not illuminated
7.1 Instructions for cleaning
Routine maintenance essentially consists of daily cleaning all the parts that can come into contact
with the foodstuffs. The cleaning instructions to be followed are listed below:
Make sure the electrical power supply has been disconnected by unplugging it from the socket.
CHAP 6 - MALFUNCTIONING
LIKELY CAUSE
Power is not reaching the power
supply circuit
Faulty
switch,
compressor
Power
is
refrigerating unit
not
Faulty
switch,
compressor
Refrigerating fluid leakage
Too high dissipation
Power is not reaching the neon light
Faulty switch or neon
CHAP 7 - CLEANING AND MAINTENANCE
thermostat,
or
not
reaching
the
thermostat,
or
Page 7 of 11
REMEDY
Make sure there is power in the
electric network
Check the correct connection of the
power supply cable (§ 7.2.6)
Check the different connections and
various electrical components and
replace them if necessary (§ 7.2.1
and § 7.2.3)
Make sure there is power in the
electric network
Check the correct connection of the
power supply cable (§ 7.2.6)
Check the different connections and
various electrical components and
replace them if necessary (§ 7.2.1
and § 7.2.3)
Check the refrigerating gas circuit
The display cabinet is positioned in a
too hot place
The automatic closing system is not
operating correctly, take care over
the closure of the sliding doors.
Make sure there is power in the
electric network
Check the correct connection of the
power supply cable (§ 7.2.6)
Check that the switch on the neon is
on.
Check the different connections and
various electrical components and
replace them if necessary.