- ページ 8

実用車 Burley Tail WagonのPDF 取扱説明書および安全マニュアルをオンラインで閲覧またはダウンロードできます。Burley Tail Wagon 12 ページ。 Burley 2-wheel stroller kit
Burley Tail Wagon にも：パンフレット＆スペック (5 ページ), 取扱説明書および安全マニュアル (12 ページ), 取扱説明書および安全マニュアル (9 ページ), 取扱説明書 (12 ページ), 取扱説明書 (8 ページ)

Converting from Strolling to Trailering

Remove retaining pin from tow bar, slide bar forward and line up

hole with rear receptacle hole. Insert pin through both holes

rear

and fasten safety pin securely. Loosen knob and swing wheel up

into "BIKE" position. Tighten knob.

Now attach trailer to bike, using Burley hitch.

Hitching Trailer to Bicycle

1. Remove quick release lever assembly from bike.

2. Line up hole on flat side of hitch upper arm with left

(non-chain ring side) rear dropout hole.

3. Reassemble quick release assembly through hitch and

dropout loosely.

Figure 3

4. Slide hitch receiver end of tow bar between hitch side arms,

and line up holes. Racks, bags, or fittings should not interfere

with hitch; if there is interference, contact Burley.

B U R L E Y P E T T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L

Figure 2

5. Open retaining pin and insert through holes. Rotate pin's

spring clip and close.

6. Tighten and close quick release lever, with lever pointing to

rear of bike.

7. Wrap safety strap twice around inside of chain stay and then

over hitch body. Fasten hook to D-ring on tow bar

end.

Figure 4

Hook fastened to

D-ring on tow bar