- ページ 7

アンプ Burmester 036のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Burmester 036 13 ページ。 2-channel power amp

ページを印刷する

The connectors of the 2-channel power amp 036 are located on the rear panel. We strongly recommend leaving all

components switched off while connecting the power amp. For optimal connections also pay attention to the manual

of the driving unit.

AC mains input

Before connecting the power amp please check that the input voltage of the 036 is

equal to the local voltage of your wall outlet.

The AC mains input (11) is located on the rear panel. Make sure that the AC mains

switch (10) is set to OFF. Connect the power cord with the AC mains input (11) and plug it

into the wall outlet.

Inputs

The 036 offers two balanced Inputs (4) and (9), which will be connected to the

corresponding outputs of your pre amplifier/surround processor.

The pinning of the balanced inputs (XLR 3pin) is: PIN1=GND, PIN2=NEG, PIN3=POS.

We strongly recommend using balanced connections to take full advantage of the

extraordinary sound quality.

If necessary, the inputs can be converted to unbalanced mode by using the supplied

adapter plugs.

Binding posts

We utilize the same binding posts for our power amplifiers as for our loudspeakers. These

high-grade terminals for speaker cables have proven their sonic excellence and functional

convenience a thousand times over. Speaker cables can be connected via pure-copper

spade lugs or via banana plugs.

CAUTION: The binding posts of power amplifiers may carry dangerously high voltages. Do

not touch them while the power amp is switched on.

Outputs

CAUTION: We strongly recommend leaving all components switched off while connecting

the power amp. This will avoid shorting out cables that have not yet been completely

hooked up. Connect the speaker cables to the power amplifiers only after ensuring that they

are hooked up correctly to the speakers.

Before turning the amp back on, make sure that all cables have been connected firmly and

correctly with respect to polarity (POS, NEG) as well as frequency (LOW, HIGH/MID). After

a new hook-up, we recommend increasing the volume slowly until you are sure that

everything is connected correctly.

IMPORTANT: Only connect the speaker cables to the intended binding posts of the power

amp/loudspeakers. Never insert the speaker cables into a wall socket/AC mains.

Remote

Connecting DC OUT (12) to the corresponding DC IN-jack of another BURMESTER-unit

offers to switch on or off this other unit simultaneous by the 036. In this case, 036 has the

master function.

Connecting DC IN (13) to the corresponding DC OUT-jack of another BURMESTER-unit

offers to switch on or off the 036 simultaneous by the other unit. In this case, 036 has the

slave function.

Phones jack

The phones jack PHONES (14) requires a 6.3mm stereo plug. When headphones are

connected, the speakers are switched off automatically and the volume level is reduced.

When pulling the phones plug from the jack the speakers are being switched back on and

the volume level is also lowered.

Using the phones jack when the amplifier works in MONO or BI AMP operation, requires an

adapter, which brings the two channels together.

CONNECTING