- ページ 6

オーブン Diamond BRIO43/X NのPDF 設置 - 使用 - メンテナンスをオンラインで閲覧またはダウンロードできます。Diamond BRIO43/X N 11 ページ。 Electric fan ovens
Diamond BRIO43/X N にも：設置 - 使用 - メンテナンス (12 ページ), 設置 - 使用 - メンテナンス (12 ページ), マニュアル (12 ページ)

ページを印刷する

Do not obstruct any air vents or drains present on

the appliance.

Do not tamper with appliance components.

4. REFERENCE STANDARDS AND LAWS

Install the appliance in accordance with the safety

standards in force in the country.

5. UNPACKING

Check the state of the packing and in the event of

damage, ask the delivery person to inspect the

goods.

Remove the packing.

Remove the protective film from the outer panels.

Use a suitable solvent to remove any residual

adhesive from the panels.

6. POSITIONING

The overall dimensions of the appliance and the

position of connections are given on the installation

diagram at the start of this manual.

The appliance is not suitable for integrated

installation.

Position the appliance at least 10 cm from adjacent

walls. This distance can be reduced in the presence

of non-combustible walls or heat-insulated walls.

The appliance has no moving parts which could

affect the stability, therefore, are not provided for

locking elements to the ground.

7. CONNECTIONS

The position and dimensions of connections are

given in the installation diagram at the end of this

manual.

CONNECTION TO THE WATER SUPPLY

The appliance must be connected to a potable

water supply (max 35°C. ). The water inlet pressure

must be between 1, 5 - 3 bar. Use a pressure

reducer if the inlet pressure is above the maximum

permitted level.

Install a mechanical filter and a shut-off valve

upstream of the appliance in an easily accessible

point.

It is necessary to have a supply of drinking water

with hardness<10 °F to avoid circuit blockage.

Make sure the water circuit is free of ferrous

particles before connecting the filter and the

appliance.

Seal any unused connectors with a plug.

Once the appliance has been installed, check for gas

leaks at the connection points.

INSTALLATION OF A WATER SOFTENER IS

RECOMMENDED TO AVOID LIMESTONE

DEPOSIT.

WATER DISCHARGE

Water discharge is located in the lower part of the

oven and is to be connected to a rigid pipe, the

diameter of which should fit the discharge

connection.

The down flow pipe must be fitted at least 20 cm,

underneath the attachment.

Any discharge blockage can be the cause of any bad

odours in the baking chamber or of any steam

coming out of the door.

ELECTRICAL CONNECTIONS

Check that the appliance is designed to operate at

the voltage and frequency of the power supply

present on site. Check the details given on the

appliance dataplate.

Install upstream of the equipment in an easily

accessible place, an all-pole disconnecting device

with a contact gap of allowing full disconnection

under the conditions of overvoltage category III.

A flexible rubber cable with insulation specifications

not lower than type H05 RN-F must be used for

connection.

Connect the power supply cable to the terminal

board as shown in the wiring diagram supplied with

the appliance.

Secure the power supply cable with the cable

clamp.

Protect the power supply cable on the outside of

the appliance with a rigid plastic or metal pipe.