- ページ 5

浄水器 Aquasana AQ-5200.55のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Aquasana AQ-5200.55 9 ページ。 Under sink

INSTALLATION STEPS

Attach Filter Housings

Attach each filter housing to the bottom of the system manifold.

Ensure connection points are correctly aligned, then push the

filter housing up while turning clockwise. Continue this step for

each filter housing.

A. Attach first Claryum® filter housing (red).

B. Attach second Claryum® filter housing (yellow).

C. For AQ-5300: Attach Pre-Filter housing (black).

D. For AQ-5300+: Attach Pre-Filter housing (green).

AQ-5200

NOTE: Ensure all filter housings are attached and locked in place. Ensure the

filter housings are not on an angle while attaching. This may result in damage

to the o-ring. Do not lubricate the o-rings.

AQ-5300

AQ-5300+

Connect Water Supply Lines

A. Push the faucet tubing from the

brass tee end into the inlet side

(left side).

NOTE: Ensure tubing is completely inserted so leaking does not occur. A fully

connected tube must be inserted up to an inch.

A. Turn on cold water and check for leaks.

B. Flush water for 10 minutes to remove carbon fines.

NOTE: Do not drink flushed water.

INSTALLATION STEPS

B. Push the tubing from the

faucet side into the outlet

side (right side).