- ページ 3
浄水器 Aquasana AQ-PWFS-RB1のPDF セットアップ方法をオンラインで閲覧またはダウンロードできます。Aquasana AQ-PWFS-RB1 5 ページ。 Powered water filtration system
Aquasana AQ-PWFS-RB1 にも： 使用方法 (3 ページ)
ページを印刷する
Easy to install
Prepare the filtration dock
• Unpack and unwrap contents of box
and remove plastic wrapping from
smart filter cartridge.
• Install smart filter.
(grooves)
With filtration dock
facing forward, use
grooves on the left
hand side of the top
cover to slide the top
cover to the right
until it lifts up and off.
Indicator Light Key:
Drop the filter cartridge into the
opening on the dock as shown (male
end up). Next, place the top cover back
on the dock. Pressing down firmly,
Once filter is installed, plug the filtration dock into an electrical outlet.
IMPORTANT
Flush system one
cycle before drinking
(reset)
Please note:
Water may leak
from circular
valve when
inserting pitcher
or dispenser onto
dock.
Lights will be on only while the system is running.
SOLID BLUE
BLINKING RED
FILTER IS AT
FILTER REACHED 100% CAPACITY
FILTER IS AT 90% CAPACITY
OPTIMAL PERFORMANCE
CHANGE FILTER
rotate the top cover back to the left
until it is fully closed and locked in.
Once pitcher is attached to the filtration
dock, it will automatically begin filtering.
There will be a 5-10 second delay before
the outer reservoir starts to fill.
The system will run until the center reservoir is completely empty. Do not refill center reservoir with
unfiltered water if there is still filtered water left in the outer reservoir. System will overflow.
Please wait for the front light to turn off before removing the pitcher from the dock.
SYSTEM WILL NOT RUN
WITHOUT WATER
SOLID RED
To dispense filtered water, push
button on reservoir lid. There will
be a 5-10 second delay for water
to filter through.
Please wait for system to finish
filtering before removing the dispenser from the dock.
Once dispenser is removed there may be residual water left on the dock; this is normal.
Pitcher
• New filters must be flushed (1 full pitcher) before drinking.
Note: Filtering may take up to 2 minutes to begin on the initial run.
• Place lid on pitcher.
• Fill center reservoir with cold water through drop-shaped opening.
• Place pitcher with lid onto the filtration dock until fully locked in.
SYSTEM WILL NOT RUN WITHOUT LID
SECURED ON PITCHER OR DISPENSER
Dispenser
• New filters must be flushed (1 full dispenser) before drinking.
Note: Filtering may take up to 2 minutes to begin on the initial run.
• Place lid on dispenser.
• Fill dispenser with cold water through drop-shaped opening.
• Attach dispenser with lid onto the filtration dock until fully locked in.