- ページ 6

浄水器 Aquasana WELL WATER Rhino EQ-WELL-UVのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Aquasana WELL WATER Rhino EQ-WELL-UV 12 ページ。 Whole house water filter

INSTALLATION STEPS

Pre-Condition Rhino Tank

NOTE: It's imperative that this system is flushed properly prior to final installation.

The granular carbon used in the bottom tank contains 1-2% by volume of carbon

fines that must be flushed out prior to use. Surge flushing is the best method for

purging these carbon fines from the media bed.

1. Once out of the box, keep the tank upright

at all times as to not apply pressure to divider.

Remove shipping caps from inlet and outlet

ports. Using supplied adapter, connect a garden

hose to the inlet port so the water will flow into

the system and out of the outlet port.

2. Slowly turn faucet on and allow discolored water

to flow from outlet into a suitable drainage area.

The first few gallons will appear black and cloudy

due to carbon fines.

TIP: You may need to slightly shake the tank to help

remove carbon fines.

3. After an initial 15-minute flushing, begin

a period of "surge flushing" by turning water

supply on for 30 seconds and then off for 30

seconds, repeating cycle for 15 minutes or until

initial surge of water is completely clear and

free from discoloration and cloudiness.

4. Disconnect the system from the garden hose,

be sure the white washers are properly set

inside the inlet and outlet ports, and position

the system for installation.

Select Location

1. Pick an appropriate installation location. Unit must be installed in an

area where the main water line enters your home, before connecting

to the water heater.

2. Turn off the main water source prior to installation. Drain water from

lines to relieve pressure by turning on a faucet inside your home.

NOTE: DO NOT install after the water heater or on the hot water line.

Components and installation will vary.