- ページ 2

ウォーター・ディスペンサー Aquasana OptimH2O AQ-RO3-RのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Aquasana OptimH2O AQ-RO3-R 4 ページ。 Reverse osmosis under sink water filter

ページを印刷する

INSTALLATION STEPS

Shut off the cold water valve

the system by turning on the dedicated faucet. Once there is no longer any

water flowing, you can proceed with replacing the filters.

Unbox filter replacements

match the circle indicator on each filter housing.

Remove each filter housing

housing to the left. Pull down to detach. Ensure the filter housings are not on

an angle while removing. This may result in damage to the o-ring.

Holding the filter

housing over the sink,

open it by turning the

bottom counter-clockwise.

Pour excess water down

sink drain. Pull down on

dirty filter to disconnect it

from the filter housing.

Continue this step for the

second filter housing.

While the housing is open,

inspect each o-ring for damage. If damaged, replace immediately. If

misaligned, gently move the o-ring into place.

NOTE: If filter housing is too tight to disconnect by hand, please use the plastic

wrench included with original system.

NOTE: Must replace housing every 5 years or risk property damage from leaks.

Call 866-662-6885 to order.

NOTE: Do not use with water that is microbiologically unsafe or of unknown

water quality without adequate disinfection before or after the system.

under the sink. Release the pressure from

and remove plastic. Each filter is color coded to

from the system manifold by turning the filter