- ページ 25

ビデオカメラ Panasonic AG-AC160AEJのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Panasonic AG-AC160AEJ 42 ページ。 Broadcast-grade camera recorder with 22x zoom lens and 2.2 megapixel u.l.t. image sensor
Panasonic AG-AC160AEJ にも：クイックマニュアル (1 ページ)

ページを印刷する

Charging lamp

ON: Charging

OFF: Charging complete

Flashing: See below

If the charging lamp is flashing

Confirm that there is no dirt, dust, or foreign

substances attached to the connectors of the

battery or the AC adaptor and ensure that the

adaptor has been connected correctly.

• If there is dirt, dust, or foreign substances on the

connectors, disconnect the power plug from the

socket before cleaning.

• If the charging lamp continues to flash, the

battery or the AC adaptor may be damaged.

Consult the dealer where it was purchased.

Charging time and available recording time

standards

Battery

Voltage/

model

capacity

7.2 V/

CGA-E/625

5800/5400

(bundled)

(typ./min.)

mAh

7.2 V/

VW-VBG6

5800/5400

(optional)

(typ./min.)

mAh

• The figures in the preceding table are for normal

temperature conditions (temperature 25°C (77°F)/

humidity 60%). This only serves as a guide

since charging may take longer in high or low

temperatures.

• Charging may take longer if the battery has not

been in use for a long period of time.

• Given here are the standard maximum continuous

recording times when recording in PH 1080/60i

(PH 1080/50i) mode using the viewfinder with no

connections to any external devices and with the

LCD monitor closed.

• This serves only as a guide as available recording

times may vary according to usage conditions.

• Charging times are based on the time to charge

batteries from an empty state.

Maximum

Charging

continuous

time

recording

time

Approx. 5

Approx. 3

hours and

50 minutes

30 minutes

Approx. 5

Approx. 3

hours and

50 minutes

30 minutes

Remaining battery capacity display

When using Panasonic batteries that are

compatible with this product, the remaining battery

capacity is displayed in minutes.

[

] 1h30m

The time remaining (as shown previously) is

displayed after a brief pause.

• As battery capacity decreases, the display will

change as follows: [

[

][

]. When there are only 3 minutes

or less of capacity left, [

in red, and when the battery becomes empty,

[

] will flash.

• The remaining battery capacity may not be

displayed correctly when the battery is used in

high or low temperatures, or when the battery

has not been used for a long period of time. To

ensure that the remaining battery capacity is

displayed correctly, use the battery completely

from a fully-charged state and charge it again.

(Remaining battery capacity may still not be

displayed correctly if the battery has been used

for long periods in high or low temperatures,

or if the battery has already been recharged

numerous times.)

• This only serves as a guide as remaining battery

capacity display times may vary according to

usage conditions.

• The remaining battery capacity display will

momentarily disappear when switching between

modes, when conducting REC CHECK

operations, or when changing the LCD brightness

since the capacity is recalculated during these

times.

• This is not displayed when using the AC adaptor.

• The battery and the camera itself becomes hot

while it is being used or charged.

• Available recording time is reduced if you

repeatedly start and stop recording.

• The battery takes longer to charge when it is

warm.

• Using the AC adaptor near radios may distort

their sound. Keep the AC adaptor 1 meter or

more away from radios.

• The AC adaptor may make some noise when

in use, but this is normal.

• The battery cannot be recharged when a DC

cord is connected to the AC adaptor.

][

]

] will be displayed