- ページ 32

ビデオカメラ Panasonic AG-DVX100PのPDF セットアップをオンラインで閲覧またはダウンロードできます。Panasonic AG-DVX100P 42 ページ。 Panasonic ag-dvx100b: quick start

TCG

This item selects FREE RUN OR REC RUN, as explain its best to leave in the REC

RUN mode.

First Rec TC

This item allow the user to select the time code that will be used when

recording is started.

PRESET: here the time code is recorded using the value set in the TC PRESET item serv-

ing as the initial value.

REGEN: in this mode the time code is regenerated from the time code on the video tape

TC PRESET

This item is used to set the initial value used, when the PRESET in First Rec

TC is selected.

Note: When the 24P or 24P ADV modes are used you must set the frame value to 0 or a

multiple of 5. If you use any other value the time code recorded will shift.

1394 UB Regen

This item selects the user's bit to be recorded when the DV connector is

used.

OFF: The user's bit selected in the UB Mode item is used for the recording.

ON:

The user's bit of the signals input of the DV connector is used for recording.

Note: When set to ON, this setting takes precedence over the UB MODE item setting.

The user's bit is not recorded if the signal does not contain the user's bit information

And when there is no signal supplied to the DV connector the UB MODE item is used.

UB Mode

This selection allows the user to set up the information to be recorded as user

bits. The user may select one of 5 items:

User:

the user's information, which is selected in the UB PRESET item.

Time:

The time that the recording was made.

Date:

The date that the recording was made.

TCG:

The time code generator's value is recorded.

FRM Rate:

The frame rate information for frame conversion is recorded. This is a 8 bit

digital number, which contains the following information. The user's bit value verification

information, the frame sequence number, the frame rate information and the recording con-

trol information.

UB Preset

This item is used for setting the user's bit, make sure that USER is selected in

the UB Mode item setting. The user's bit has 8 bits, which can be set 0 to 9, A to F