- ページ 4

水ポンプ AquaScape 40040のPDF マニュアルをオンラインで閲覧またはダウンロードできます。AquaScape 40040 16 ページ。 Smart pond dosing system

ページを印刷する

Installation

SETUP

• It is recommended to place the Smart Pond Dosing

System XT as close to the water feature as possible to

minimize the distance the treatment must travel.

NOTE: The XT system can be buried to conceal into the

landscape (Ex. 1). Do not bury so deep that it causes

issues with opening or closing the lid.

• Open the lid of the enclosure and connect the control

panel by sliding downward into the tracks on the lid (Ex. 2).

• Connect the power cable to the control panel (Ex. 3).

• Connect the outlet tubing from the control panel to the

closest port at the back of the enclosure (Ex. 4).

NOTE: Inlet and outlet

tubing can be determined by

referencing the indicators on

the pump cartridge (Ex. 5).

• Connect the inlet tubing to

the barb at the top of the

intake assembly (Ex. 6). Then

connect the low-treatment

power cable to the control

panel (Ex. 7).

Ex. 1

Ex. 3

Ex. 6

• Set the selected water treatment bottle into the system as

shown. Insert the intake assembly into the top of the water

treatment bottle until sealed at the top (Ex. 8).

NOTE: The XT system is designed and calibrated for use

only with Aquascape Simple Solution XT water treatments,

available in both half and full gallon bottles.

• Attach the discharge tubing to the proper fitting at the

back of the control panel (Ex. 9).

Ex. 2

• Position the opposite end of the discharge tubing where

you intend to add the treatment into the water feature.

Treatment can be dispensed directly into the pond or

fountain or into a skimmer or pump vault (Ex. 10).

NOTE: Position discharge tubing above water level.

• Attach the transformer to the dosing system power cord

using the quick-connect fitting at the end of the cable (Ex. 11).

NOTE: The unit can also be powered by an existing 12V

outdoor transformer. Each Smart Controller uses 6 watts.

Directly into Skimmer

or Waterfall Vault

Ex. 4

• Plug the transformer into a GFCI-rated receptacle.

NOTE: the unit may run once it receives power.

Ex. 5

• If desired, the XT system allows you to add multiple

treatments simultaneously using a Controller Add-On Kit

(Item #40042). This will allow you to add two half gallon

treatments simultaneously (i.e. Maintain and Clear).

Ex. 7

US (866) 877-6637 |

☎

Ex. 8

Ex. 10

CAN (866) 766-3426 | aquascapeinc.com

Ex. 9

Ex. 11