- ページ 5

浄水器 AquaScape 96030のPDF 取扱説明書およびメンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。AquaScape 96030 20 ページ。 Automatic dosing systems for ponds/ fountains
AquaScape 96030 にも：使い方とメンテナンス (16 ページ), 使い方とメンテナンス (20 ページ), 取扱説明書およびメンテナンスマニュアル (20 ページ)

5. Attach the included discharge tubing to the fitting on the

side of the control panel. Simply insert the tubing into

the fitting until it stops. The discharge tubing can either

be installed directly into the pond or fountain or installed

using the included output hose holder. The output hose

holder can be easily attached to plumbing or other

round surfaces. Refer to the installation diagrams on the

following page for more information.

Note: Install the system as close to the water feature as

possible to minimize the distance your water treatment

needs to travel.

6. Using the plus or minus buttons on the top of the

control panel, select the proper amount of gallons to be

maintained. If you are treating a fountain or small water

feature with less than 500 gallons, we recommend using

the 500 gallon setting. If the fountain or water feature

contains more than 500 gallons of water capacity,

increase the setting to the proper gallonage.

To Calculate Pond Size in US Gallons:

Length (in feet) x Width (in feet) x Average Depth (in feet) x 7.48

TIP: For new or problem ponds and fountains, we

recommend using the X2 button for the first two

weeks of operation.

☎

www.aquascapeinc.com |

☎

CAN 1-866-766-3426 |

US 1-866-877-6637

7. Priming Mode - When first setting up the system or when

adding a new water treatment pouch, the system will need

to be primed in order to push the water treatment through

the length of output tubing. To enter the priming mode,

hold the x2 button for 3 seconds until the LED indicator

light begins to flash. The system will begin to slowly prime

itself at this time. The priming mode will automatically turn

off after approximately ten minutes, returning to normal

operation. The priming mode can be exited at any time by

pressing the x2 button while the unit is priming.

8. Be sure to inspect your dosing system often to verify that

the treatment pouch is not empty and ensure proper

functionality of the system. Use the chart on page 8 of this

manual to approximate how often you will need to replace

your selected water treatment.