- ページ 4

浄水器 AquaScape 96031のPDF 使い方とメンテナンスをオンラインで閲覧またはダウンロードできます。AquaScape 96031 20 ページ。 Automatic dosing systems for ponds/ fountains
AquaScape 96031 にも: 取扱説明書およびメンテナンスマニュアル (20 ページ), 使い方とメンテナンス (16 ページ), 取扱説明書およびメンテナンスマニュアル (20 ページ)

AquaScape 96031 使い方とメンテナンス
Electrical Specifications
Transformer
• Input Voltage: 120V ac
• Input frequency: 60 Hz
• 6 Watts
• For outdoor or indoor use
• Thermally protected

Instructions

Carefully remove the dosing
system from the packaging
1. Attach the transformer to
the dosing system power
cord using the quick
connect fitting attached
to the dosing pump main
power cord. (Please
note that the transformer
should be plugged into a
GFCI rated receptacle),
the transformer included is
12V. The unit can also be
powered by an existing 12V
transformer used for 12V
lighting.
2
2. Open the dosing system
container by pressing
the four blue tabs
simultaneously on the
top portion of the dosing
system, gently lifting at the
same time.
3
3. Attach the water treatment
by removing the existing
cap included with the
water treatment, inserting
the proprietary pump tube
from the dosing pump into
the water treatment and
then seal the bag with the
included threaded adapter.
4
4. Place the attached
treatment inside the dosing
system canister.
4
Automatic Dosing System
• Input Voltage: 12V ac
• Input frequency: 60 Hz
• For outdoor or indoor use
• Thermally protected
2
3
4
US 1-866-877-6637 |
• This system has been
evaluated for use with the
Automatic Dosing System
Water Treatments only.
5
5. Attach the included discharge tubing to the fitting on the
side of the dosing system control panel. Simply insert
the hose into the fitting until it stops. Ensure that the
check valve is in the right orientation with arrow pointing
away from the dosing system. The discharge tubing can
be installed two ways, either directly into the pond or
fountain or by using included output hose holder. The
hose holder can be easily attached to plumbing or other
round surfaces. Refer to the installation diagrams on the
following page for more information.
5
6. To purge the system and get it ready for proper operation
6
press and hold the X2 button-down until the water
treatment starts dripping out into the pond or fountain. This
may take several minutes depending on the distance from
the dosing pump to the pond or fountain. Make sure to
install the dosing system as close to the water feature
as possible to avoid the water treatments having to travel
through long lengths of tubing.
6
7
7. Be sure to inspect your dosing system often to insure
proper function and to verify your water treatment is not
empty, use the chart found on page 7 of this instruction
manual to approximate the replacement frequency of your
selected water treatment.
CAN 1-866-766-3426 | www.aquascapeinc.com